Separate names with a comma.
Was this at a local bike bolt shop? Or someplace online?
Thanks for the info Ben. After looking at it. I think I can remove the bit the old brake pedal mounted too. make a slug that I can attach the old...
Hello, just picked back up on this thread. I have been working pretty hard lately on getting my bike (83 GSX250) done. I have been looking at...
Awesome, thanks for the reply. I was pretty sure that was not the way. I'll just wait to get it back in the frame.
Well, I am working on getting some progress done on the GSX project. I just dropped the frame off at a fabricator/welder to have a battery box,...
Great looking bike so far. Look forward to seeing it finished.
Well, working on getting this project back on track. I have an appointment next week to have a battery box and plate welded up to mount the small...
Thanks for the reply. I have another seat for this bike. I am going to rip off the old cover, replace the foam, and make a more flat brat looking...
Ok, it's been a while, I have done some more work on the GN. I swapped out the bars, and speedo. Replaced the front fork tubes and rear shocks...
Thanks for the reply. I hope I can figure it out. The speedo will be the last part of this project.
Just wondering if this speedo issue has been resolved. I am looking to swap my speedo out of my GN250. Just want to remove the old ugly...
Yeah, I will, this is just a test run. I'm going to check and see how the handling is. So far the change doesn't seem so drastic. I hope it works,...
So, I think I have figured out the missing/hissing from the motor. Apparently there is an o-ring that goes between the carb intake tube and the...
Thanks for the reply. Checked the it tonight. It looks like it may be leaking from the carb boot that connects to the motor.
Ok, looking for some help. I have got the GN running, however, it has a bit of a misfire/hissing at idle. I have pulled the carb numerous times...
Thanks for that. It does give me some ideas. I am hoping I can fiberglass a seat that will allow for the battery and electronics to be mounted...
Ok, the project is still going. Just been rethinking the seat and how to fit all the electronics. Plus, my battery hasn't shown up. I have also...
I picked up this bike a couple of weeks ago. I cost me very little. The seller said it wasn't running, and he couldn't get it running. I took the...
Nice find. I just picked one up a couple of weeks ago. Not looking to go all out on it, but I have bought some parts to make some minor changes....
I was thinking about taking photos of it, but I forgot and took it to the welder today.