Separate names with a comma.
Hi, I am converting my swingarm to needle bearings from rubber bushings. There is no kit for this so I am adapting from another bike. The needle...
Hi, I want to get a few bits and pieces powder-coated (not frame). Does anyone have any recommendations? Thanks, Ian B.
Hi, Thought I would make a plug for the Honda CB250RS from 1980-1985. The CB250RS is probably one of the most underrated 250cc bikes out there...
Hi, Just wondering out of interest whether people are old school or new school for their 250s. I have ridden a LOT of different bikes, but I...
Hi, I need to make some engine adapters for an engine transplant. I would like to make aluminium or steel plates and would like to get these cut...
Hi, I have a project going where I want to install a Suzuki GT250 X7 engine in a single cylinder dirt bike frame. Before I buy an X7 engine...
Hi, Although this may not pertain specifically to the '74-'78 HD 2-stroke 125/175/250 range, it is an interesting side note from the transition...
Hi, This is my 1978 / 79 Harley-Davidson / Cagiva SST 250, Euro version. The bike has not run for the last 8 years. I will document the details...
Hi, I owned a very tatty 1976 Harley-Davidson SST250 from July 1980 (when I turned 18) to May 1982. I moved up from a Suzuki TS125 after seeing...
Hi, I have a couple of AMF Harley-Davidson SS/SST250 2-strokes ('76 and '78). Long story short - rode bikes for many years (all through Uni),...
