Separate names with a comma.
Thanks for that, the symptoms I had were Ritch midrange throttle that cleared up above 3/4 throttle. This was on a 1992 ZZR600 that I picked up...
Yep, that’s the one [emoji37] Sent from my iPhone using Tapatalk
Hi All, Can someone please shed some light on the symptoms of blocked main air jets on CVK Carbs? (The AIR jet I'm talking about is the bass one...
2 Helmets......Couldn't find any bluetooth kits here in WA - asked at both stores :( Had to visit both Aldi's due to no medium full face lids (for...
2 x ZXR250 C's - WA regional area (Collie) - $1250!! https://www.gumtree.com.au/s-ad/collie/motorcycles/two-zxr-250c-four-cylinders/1155158889...
Sealant: Forch K164 - it's the ducks nuts :)
No it's only ever between 1st & 2nd on Kwaka's
Was temporarily fitted off centre (I had to drill some holes to centre it), all good now [emoji4] [ATTACH] Sent from my iPhone using Tapatalk
This happened today! [emoji4] [ATTACH] Passed inspection & registered! So stoked - thanks to the guys here & the knowledge base in these forums...
Like I said I just added the info as an FYI. Might just help someone stuck on the side of the road when that press fitted elbow falls out...
On my 250A there was an o-ring under the head of that bolt & once removed coolant bubbled out of the hole? Sent from my iPhone using Tapatalk
Yeah, I've used Devcon to seal water jackets on my peripheral ported rotaries too... It's a great product but it doesn't like to be immersed in...
I had this same issue. A simple fix it to use Loctite red (high strength) thread lock, it sets in the absence of air (anerobic) and is fuel...
Looks like a bolt [ATTACH] The top centre bolt in that image Sent from my iPhone using Tapatalk
Did you bleed the air out of the system using the bleeder near the water pump & the one above the thermostat? Sent from my iPhone using Tapatalk
Don't use a high pressure sprayer! That'll flatten all the fins out. Lower pressure from a garden hose is safer - spray it from the back not the...
[ATTACH] New tyres done! Forks done - the additional preload spacers & 10w oil have firm up the front end nicely [emoji4] I set the oil level...
Mine never gets above 1/2 scale, the fan cycles in & out every few minutes at idle once it's up to temp. It could be a lazy fan switch cutting...
Thanks for your reply, I've already lengthened the guard by 50mm
Failing water pump Failed thermostat Check those first Sent from my iPhone using Tapatalk