1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Discussion Crush washers

Discussion in 'Tech Tips' started by GreyImport, Apr 15, 2019.

  1. GreyImport

    GreyImport Administrator Staff Member The Chief Contributing Member

    Messages:
    10,929
    Likes Received:
    6,713
    Trophy Points:
    1,168
    Joined:
    Jun 14, 2012
    Gender:
    Male
    Occupation:
    Between a Rock and a Hard Place
    Location:
    North by NW NSW Oztralia - Tamworth
    My Bike:
    *Kawasaki ZXR250C *Yamaha FZR250R 3LN1 *Yamaha FZR400 *Triumph Bonneville 750 T140V *Triumph Daytona 675 *Triumph Tiger 800XC
    Flat side/raised crushable side ..... So which way ? ... or does it not matter

    20 different answers on the interweb ... well 3 anyway :D


    crush washers (Small).png
     
  2. my67xr

    my67xr Bike Enthusiast Staff Member Premium Member Contributing Member

    Messages:
    4,313
    Likes Received:
    2,383
    Trophy Points:
    898
    Joined:
    Jun 18, 2016
    Gender:
    Male
    Occupation:
    Panel Beater, Spray Painter, Custom Fabricator
    Location:
    Adelaide, South Australia
    My Bike:
    Yamaha's , 1990 FZR250R 3LN3 , 1986 XT250TS 57R , 1984 IT200L 43G, 1976 IT400C 510
    I normally put the cupped side to the block with the flat side on the back of the bolt
    I mainly use a lot of copper crush washer's, but they're just flat washers
     
    • Like Like x 1
    Last edited: Apr 15, 2019
  3. GreyImport

    GreyImport Administrator Staff Member The Chief Contributing Member

    Messages:
    10,929
    Likes Received:
    6,713
    Trophy Points:
    1,168
    Joined:
    Jun 14, 2012
    Gender:
    Male
    Occupation:
    Between a Rock and a Hard Place
    Location:
    North by NW NSW Oztralia - Tamworth
    My Bike:
    *Kawasaki ZXR250C *Yamaha FZR250R 3LN1 *Yamaha FZR400 *Triumph Bonneville 750 T140V *Triumph Daytona 675 *Triumph Tiger 800XC

Share This Page