Separate names with a comma.
It may be worth seeking them out, dowty washers appear at places that deal with hydraulics Otherwise a slightly than larger than the screw...
Dowty washers or washers slightly larger than the screws with an o-ring inserted into centre to seal and large head allen key screws might have...
OK, so the needle jets are different between because the zeal uses an O-4 needle jet, whereas the 3LN series uses an N-8 needle jet - there's a...
OK, just to check - when you say all jets replaced, that includes the needle and needle jet (emulsion tube) - yes? If you're at 15.1mm float...
Damn many young fellas would be envious and truly jealous to be in the presence of greatness to resuscitate a bike in that condition I remember...
You could flare the brass a tiny bit, reinsert it and then put a tiny amount of epoxy around in a ring over the top, it needs to be spotlessly...
The bits you need are there... Price?
Well I'm going to go for 54mm for 316cc Now if I can only get those chaps at Dayton pistons to send me some data on their forged pistons, life...
Welcome - you've come to the right place - there's some veritable gurus here
@Murdo could have saved that tank, he's a veritable, and all venerable magician
You MUST be a pirate if you're THAT concerned about a letter "R"
Those Zeal carbs are an excellent purchase - I purchased some for just that reason - to get the needle retention mechanism, BUT my Zeal carbs are...
Yes that is THE needle retention mechanism that you want to keep If the Zeal carbs throats are the same - replace all jets including the needle...
OK, well the last option is a combination of a heat gun if you have one and a left handed drill bit @GreyImport has an abundance of carbs, but I...
The plastic shims, if the same thickness, then they can be changed - also the slide housing slides out, I do actually have a set of Zeal carbs...
Silly question, but this caught someone else out - boots tightened securely onto the cylinder head? Chances they have micro cracks, but it's...
They are consistent as both @Murdo and @maelstrom have noted, the difference between them may be down to valve clearances
Interesting observation because I spent some time on forums where discussions involving Jan Thiel and the Aprilia engine development was discussed...
If, and this is a big if, the carb throat diameters are the same between the sets, definitely keep the 3LN6/7 sets complete. If however the carb...
BUT, WAIT WAIT WAIT, where the cassette deck?
