Separate names with a comma.
New clutch in, old ones were black and filled with gunk. Feels alot better. Used old spark caps but fit new leads to the old coils and now has no...
It had been sitting dry for like 10 years. Im hoping the springs are still ok. Can't find a kit that includes them Sent from my SM-G973F using...
The spark arcs to the valve cover sometimes and I think I'm losing it in 1 when it rains. So maybe wires and caps? Sent from my SM-G973F using...
All good, cracks been welded up and not leaking after a good ride. Dialed back the fuel 1/4 and has less fumes coming out the exhaust and is...
I would prefer a screw on filter setup so i wouldn't have to drop the whole exhaust every oil change. But can seem to find any fzr250 sumps. So...
Update, went to do an oil change and noticed the sump plag was leaking slightly. Put a fresh washer and a bit of gasket goo on. Tightened it...
New pump in, turned over and it fired straight up. Fixed the throttle problem with the jets too and she runs mint. Might be a little rich so I'll...
Im a bit weary of riding it with gravity fuel but checked the balance and all looks fine. Was looking at new pumps and not sure if I should get a...
I put 12v directly to the pump and got nothing. Also noticed a bit of a fuel leak when it wouldn't start a few days ago. Sent from my SM-G973F...
Ok quick update, while waiting for the interfaces to arrive decided to try set all carbs to standard and rebalance. Went to check the jets to make...
Yeah exup cables from the 400 fit perfectly and are adjusted properly using a spanner on the valve. It cycles properly when powered on everytime....
She handles nicely now but this fuel issue has me stumped. I tried adjusting piolet screw but now it's rich on idle but as soon as you give it...
And just like that it's fixed the swaying problem. Can now take both hands off and rides straight. Such an easy fix to simply align the forks....
So new steering bearings and forks fully rebuilt and it feels like it's trying to lean right and feels kind of stiff to ride. I have done the...
Got the new bushings in finally so ill be reassembling it this weekend. This is the old bushing compared to the new one. Really needed them done...
Yeah it is that bushing, there's a lip that the thing is butted up against so can't get anything behind it. The coating it pretty shot anyway so I...
The old Lower racer was warped and seized (explains why my bearings were bad) so ended up cutting it out. I thought if I froze the new racer it...
So bearings came in, went to fit them and they were supposed to be the tappered ones. But mega zip says its supposed to be the flat ones. They not...
Ordered some new bearings and racers as well as some new intake rubber, when I tried to syncronize the carbs the middle 2 wouldnt move so must be...
Couldn't find any stiff spots but there was a bit of play in it before so I tightened it a bit and that fixed the play but I think that was when...