Separate names with a comma.
Thanks, 1 other question, is it ok to use 3LN3 carbs on a 3LN1 engine.
Thanks, @maelstrom How do I contact Mike Norman for the oem rings. I’ll need to get the cylinders bored first if they don’t look good. Will give...
Ok so after looking through AliExpress I have managed to find a lot of the stuff I’ll need. As no one has managed to find conrod bolts I will...
Thanks, do you know what material are the valves made from, if they have some surface rust looking stuff on them do you think they will be ok or...
Hey Guys, Looking to fully rebuild my 3LN1 engine, just wondering, is there an English translation of all the torque specs. Also, is there a...
Thanks guys, Your advice is noted. I will tackle each issue one by one and will eventually get there. I know I have said it a million times but...
I didn’t change much @ruckusman just the better throttle cable, brakes, brake lines and front master cylinder that you sent me. I have now...
This is also really hot. Even with a new voltage regulator. [ATTACH]
Ok so I’m still gobsmacked, I swapped the carbies over to the other engine and it starts and runs fine so it’s definitely not the carbies. I...
Keep in mind this engine(different bike) does not blow smoke so I assume no valve stem issues. However, there must be another issue. Thanks for...
Keep in mind this engine(different bike does not blow smoke so I assume no valve stem issues. However, there must be another issue. Thanks for...
Not anymore, I picked up an fzr without a broken front fork and merged the best bits of the two onto one. This one looked newer so I put the...
Guys I’m at my wits end, I spent all day ******* around and I feel like I have gone 30 steps backwards now. I tightened the carbs properly to the...
Thanks so much Blair, I haven’t done this yet. This is likely the issue. Although does it also explain the surging? Or might that be due to a...
I put new plugs when I refreshed all the engine fluids and rebuilt the carbs. Maybe the coils are weak/having an issue but it sounds like it’s...
Hey guys managed to get the brakes finished and took it for a test ride today. Has had some issues. The fuel levels are all set properly and the...
Oh and also setting the correct fuel level is crucial.
At least check that all the jets are in the right order and the needles are correct and the clip positions are correct for now. Mine had all of...
Hey Brandon, Don’t fear the carb rebuild, it’s not as daunting as it seems. These guys helped me through it and now I know the carbs back to...
No worries @ruckusman. There’s no rush, my last exam is 1st of July and then it’s full steam ahead on the restoration. Hopefully by then you’ll be...