Separate names with a comma.
No m8 ended up swapping full bottom end for Gj74a one,,,
Thanks they seem to be identical ;)
i mixed up my cam shafts,,, 1 set of bandit 250 gj74a and 1 set Gsxr 250 gj73a not sure which is which how do you identify ? Thanks Baza
I done pretty much same to my gj73a Cobra,, Naked Gsxr250r,,,, Luckily I had a gj74a bandit head that I am rebuilding at the moment,,, [ATTACH]...
Cheers m8 it wouldnt have happened without your help thats for sure ,,,,, I do feel proud to be riding it m8, today was amazing, proper rewarding...
Few pics from day out today,, the Sun was shining over the Yorkshire Moors :) Runs a treat if it was gona fail it woulda done today,,,,, Im made up :)
lilttle update :- Carbs now re-built with new emulsion tubes needles jets seals ect,,, Never tuned carbs before,,, or rebuilt an engine like this...
[ATTACH]
yeh dont look to much of a job replacing them, one has been done before, and as its only for the choke circuit i guess it wont have a lot of use,,...
Ive just broke one off my mikuni Carbs, and others have cracked or been repaired,, so bought some brass pipe to replace them check my last posts,,...
Yeh i got them for the needles tubes and jets ,,,,, the seals dont look half as good as the litetek ones,,, i will probably replace once i sorted...
Ordered some Bass pipe 4mm OD & 3.5mm ID also 3.5mm OD & 3.0 ID to see which fits best,,,,, one of the carbs has had a similar repair so gonna...
Got fresh Carb kit seals, emulsion tubes needles ect Keyster Kits jus got here, so stripped em again and found another problem,,,, the Brass tubes...
https://www.toolstation.com/abracs-poly-abrasive-disc/p22693?store=GC&utm_source=googleshopping&utm_medium=feed&utm_campaign=googleshoppingfeed&gcl...
https://www.kfm-motorraeder.de/cms/en/genuine-spare-parts/suzuki-spare-parts?itemid=3140205C00000 check that one m8 about 200 posted :)
I bough my engine knowing the condition of magnets,,,, i gona put some more resin on them and keep a check on em, but will replace the flywheel in...
check the magnets for cracks or signs of cracking, the white lines on mine is what i believe is the first signs of them going,,, still some life...
[ATTACH] [ATTACH] [ATTACH] [ATTACH] Just stripped and re-built carbs and put to stock settings,,,,,,
Yeh gona get out my tools and start some investigation soon,,,, im not to concerned,,, its only a teething problem as when it goes its sound...
yeh vac operated petcock,, it idles ok m8,, it will start & tick over fine ,, jus when run up the road after beeing under load it dies, then it...