Separate names with a comma.
A 300 mile break in is about 2 tanks of fuel! When I say going easy on it I mean frequently accelerating at a light to moderate throttle opening...
Engine has just been overhauled with new big end bearings, pistons and rings, cylinders have been honed etc. And never got to ride the bike before...
I trimmed mine with a cutoff wheel in a Dremel and small grinding burr to neaten it up
bike got its maiden voyage today! was having some issues with the gear lever not returning properly on gear changes. it had a very slight bend on...
I had mine off recently, from memory there is enough room with some wiggling to grip the shaft the knob is attached to with some needle nose...
I got the rims back all completed. The damage on the front one had to be built up by welding it and then turned back down in a lathe. They were...
I wasnt completely happy with the fuel tank so got it acid dipped yesterday, it came up nicely and all clean inside with no rust remnants. Got...
Completed recovering one of the seats today, then got most of the way through the pillion seat and ran out of staples. Thats on hold until I get...
I got the rest of the fairings fitted and secured properly today, using rubber grommets to help prevent cracking around the mounts. The fitment of...
Got the carbs installed as well as the airbox and all of the remaining hoses and vent lines routed. The airbox to carb boots were replaced with...
Its been a while since any updates, I had some bother getting the butterflies aligned nicely in the carbs that were getting rebuilt. That plus...
Fairings arrived today, they look great and were well packed. Paintwork looks very nice, the plastic is definately a bit thinner and more flexible...
Yup, they are out too, Did plenty of reading on here before stripping them :)
Got started on the carbs today, they were pretty filthy on the outside, actually not too bad on the inside. So lots of scrubbing before splitting...
No engine number on mine, it was imported into the UK from Japan in the early nineties. Just has the usual 1HX start and the rest blank, might get...
Its a 3LN1 bike with 3LN1 carbs and a slightly later engine fitted with the external spin on filter.
Connected up the cables for the exup valve today, Added a new Connector for the neutral and oil switch wires as the original was missing and the...
Little more done today, take one moderately crusty exhaust, few hours with a wire brush in the drill and some paint after. And a nice new danmoto...
Got some time to do a bit more on the bike today, stripped all the parts off the radiator, gave everything a good clean, straightened some bent...
Hmmm, had a look through the remaining parts and I seem to be missing that one. Will have to see if I can find a used one on ebay. I do have this...