Separate names with a comma.
Also regarding the pistons, this is how an OEM vs alibabba one looked like: With the rough one I wasn't too comfortable putting it inside the engine.
Pictures how the gasket looked like. In my opinion not too bad.
Hey, I did buy the head gasket from GJ77A and cut it in specific way so that it fits the head. So far it has worked perfectly - with this I mean I...
It's okay, I will order basically everything that I can and then put it back together. Pictures coming soon!
Well I was expecting to have replace a lot of thigs and that it will get quite costly. I ordered placed and paid already for the cylinders , which...
Yes but I still would like to replace the pistons and valves as well. So it would be much more easier to bore it and use oversized pistons
But is there a difference in the pistons? Based on the dimension I didn't see any difference.
So a small update, I have disassembled the engine and the crankshaft with the rods are fine. The only problem that I have is that the bike was...
One more question I have about the crankshaft pins. Is there a huge difference between the colors? There are black, yellow etc but some places...
Yes , I already are using this page for codes / parts , however some of them look very similar with different part numbers.
Okay, will try to do that in following weeks. Also is there a huge difference between GSF250 GJ74A and GSF250 VY(E24) (2000). Basically I can...
I don't know yet . But I think that should be done , since the engine will get disassembled anyway and I will change the cam chain as well.
Yes , I have already ordered rebuild kit for the carbs and new fuel cook assy as well as the intake pipes , head gasket cylinder cover gasket and...
The bike ran well and started cold without any problems (I had zxr250 that had very low compression and that thing could only be started by...
The bike has done 19000 km's , so about 11 000 miles. These bikes are hard to come across in Europe, so it's in my interests to restore it properly.
I measured the compression and it was around 100psi for all the cylinders and the compression was equally low in all of the cylinders. I will...
Hello! I am currently rebuilding my Suzuki GSF250 GJ74A engine. It is possible to find parts for the engine, however, I am currently struggling to...
Hello! I'm currently rebuilding engine myself and I was wondering nr.1 where did you bought valve stem seals? nr.2 did the copper-coat worked for...
Also, is there some manufacturers that produces whole cylinders for 250cc inline 4's? Since I'm doing rebuild, the easiest way would be just to...
Hello! I recently purchased a Suzuki gsf250 (bandit) and already rebuild carburetors and some few more minor things. One of my friends is a...