Separate names with a comma.
Awesome, I have sent an email
Ill wait for their reply incase I can pay a bit extra for shipping before placing my order
I assume this comes direct from Thailand, what sort of shipping times are to be expected compared to something like @XCite Bikes being about 5...
So I think current issue is one of my carbs (#1) is not getting fuel. Because I’ve managed to “drain” the bowl of carb #1 and comparatively not...
I think its because I had used some carb cleaner on Mmmmm on the plugs and so it used it for fuel. So a complete fluke because I can’t get it to...
I haven’t pulled the carbs off yet but just cranking it, it sounds like it’s so close, like I could hear some cylinders firing but it just never...
I did inspect all the injectors but I could not inspect the Venturi hole, so I’ll pull the carbs off again and try and dig out if there’s anything...
Cleaned plugs and started with half choke and a tad of throttle and engine roared to life but did die after a couple of seconds I would have held...
yeah I would assume they are not synced. and coils are setup to match the second graphic
I can get it to a point where if I hold the starter for an extended amount of time I can get it running and then it will run at very low rpm by...
I have inspected all choke plungers and the look clean, can’t find any debris
So I went to go do the compression test however the kit that was leant to me does not contain the correct fitting for my 10mm plugs :( off to...
good good, glad I checked before chucking them in. At least they make good spark testers
I will try this too, cheers.
coil issue was sorted. I had put the pilot screws at 2-1/8 with no start, turns out mate had flipped the kill switch on me whilst I was on the...
Does this new plug not having a shank mean it’s incompatible with the block [IMG]
yeah that’s what they were set to, currently have them set to 2-1/8 as described above, yet to try that out. I guess I could also try 1.5?
Plugs for reference [IMG]
Pilot screws look like the above
Same thing just happened to plug 2 it looks like the leads were just stuffed over the screws on the inside, is there a way to fix this?