Separate names with a comma.
I'm sure there are better products but I had decent results with CT-18. I think I mixed it roughly at about 100:1 when I did the carbs on the ZXR.
Been a while so here is a status update: Flywheel cover and water pump housing(s) blasted and painted [ATTACH] Freshly baked ... [ATTACH]...
Item Name - Valve Shims x 16 Item Description - I believe these are OEM shims, I have no further use for them. I have measured them as: 1.8 1.85...
Thanks mate. I actually bought a welder I didn't need a while ago - sounds like a learning opportunity !
I decided to dig into the cooling system a bit more as I wanted to paint the pump cover to match the freshly painted stator cover. Impeller has...
Cam timing sorted. Valve cover soda blasted and painted the little discs that hold the oil seal against the cover. Coil On Plug wiring done, I...
You could always try to repair the pinhole with some JBweld ?
Before I undo the cam holder (I like how the tightening sequence is stamped in it BTW) ... is it 28 or 29 pins between the inlet and exhaust...
Missed a couple of pics. Mr Glove [ATTACH] Shims going in (I installed spark plugs immediately after taking this photo!) [ATTACH]
2022 update 1: I ended up measuring all valve clearances a second time and quickly became very confused as all the valves had seemingly tightened...
This was the ebay listing heading: "Kawasaki Versys KLZ1000 KLZ 1000 2019 Ignition coil set coils 21171-0033" I'd recommend using the Kawi part...
Ebay for the modest sum of $120 This is their store: https://www.ebay.com.au/usr/bike_spares_australia?_trksid=p2047675.m3561.l2559 The following...
And the shopping continues.... [ATTACH]
Shims arrived ! Very quick turn around considering the time of year. [ATTACH]
Happy new year everyone! Thanks @Linkin for the advice. Chain ordered (un-jointed). I'll check the tensioner for wear, I wasn't able to...
End of year update ..... I'm going to try use less words and more pictures Carbs are back together and bench sync'd using a round feeler gauge....
Hi Blair Just for my own sanity ... is the breather tube I have Kawasaki part no. 92005-1204, or 92005–1314 ... or something else ? You've...
Update: At the risk of being a one trick pony, bank screws loosened using a sharp punch and getting a small rotation to happen - I recently...
Thanks very much @GreyImport You guys do a great job running this forum by the way :thumb_ups:
So the highly regarded theebond cleaner is this one ?...