Separate names with a comma.
Or that time I unscrewed the fuel can to let it vent in the heat, nipped it back up without thinking and came back to it crushed when I remembered...
After I wrote that I decided to educate myself, some reasonably credible sources say ~50% is achievable, and 100°C is getting up there, it also...
Sounds like we're into nuclear engineering territory, although by the what you've described you may be able to have sheet bent to a few of the...
This info is GOLD - thank you I just cobbled together a ridiculous contraption to measure if the bore for the buckets is perfectly concentric with...
Your encyclopedic knowledge, and recall of that knowledge, continues to impress Mr Grey
I just checked my reservoir, no signs of any chain contact in the past - there's isn't a chain on it right now to check - mine's a 3LN1 with the...
Too cheap to pass up IMO The price of yours is much more reasonable than what I found previously, tubes at $25 each gave me pause for thought
Just thought I'd pass this one, I bought some diamond lapping paste - I had researched it previously and it was about ~$25 a tube from jewellery...
AAH, OK, I didn't realise that model uses the fuel cell and tank cover - I do actually like the fuel cell concept as it puts the fuel at a lower...
OOH, where did you get that quick fill fuel cap? It does look very schmick!
Those prices for valves and springs are actually very reasonable compared to some prices that I have seen
Valve/cam timing is a visual check at the LHS end of the cam - I have a feeling (not an actual verified fact) that if a cam were one tooth out,...
The TCI unit gives the coils 12v for a brief moment each cycle to charge them (dwell time) then abruptly cuts that voltage to generate the spark -...
You've covered all of the other bases, good troubleshooting methodology. Check and double check the pickup connections - we had @gregt recently...
Absolutely fantastic work as always, that was more of a resurrection than a restoration and it looks better than it ever did new
That's a beautiful thing, when I took an FZR250 cylinder head to the local performance engine builder, they had a Mira seat cutter. Really nice...
Yeah sorry about that - I need to finish my Quick change tool post fitment as this shimming cutters and parts to height is nucking futz. I'm...
@Gen has got the modified neway cutters I believe. @gyro gearloose if you need a 7mm arbor with 3.5mm pilot for neway cutters I'd get the 3.5mm...
That part below the springs? Does it block a significant portion of the outlet to cut down on the noise?
Out of interest, what does the baffle look like?