Separate names with a comma.
You wouldn't happen to have a set of cylinders for sale?
https://www.gumtree.com.au/s-ad/natone/motorcycles/1998-kawasaki-zx250-lams-approved/1239086710 800 for an unregistered ZXR 250 with some carb...
Name - ZXR 250 Complete Tyga kit Item Description - I have a complete Tyga kit for a ZXR 250. Paint is rough and will need sanding back and...
https://www.gumtree.com.au/s-ad/parkwood/motorcycles/yamaha-motor-cycle/1173200043 $2000 for an 86 FZR400 Parkwood QLD 4214 [ATTACH]
I had this issue when I installed the 240km/h speedo on my bike, a 10k ohm resistor on the pink wire from the CDI spliced into a ground fixes it.
21119-1316 (i believe) was the CDI number, and No, I didnt sell the tyga kit.
Just found out the CDI that was on my bike was a ZR250 Balius CDI :confused:
So just an update. I was riding in the rain, and the bike started to stutter really really badly, ended up dying on the side of the road. I...
Literally every commodore. SR20DET powered 180sx.
So far this is what I've done. Wired a 10 ohm resistor into the plug end and spliced it into an earth (black and yellow): 16000rpm limit Wired a...
Well, turns out under load that I'm still stuck at the 16000 limit. I'll check the wiring again when I get home and see if it's wired up properly...
no speedo wire, looks like a resistor and an earth is my only option. -EDIT- Wired in the resistor into the pink wire, then spliced that into a...
Well, I took my speedo off to discover that there are only 2 sets of wired going to it, each set turns ont he tiny globe to illuminate the speedo,...
Haven't been on lately. but here's an update. Fork seals got done and I cut down the exhaust, and most things have been fixed up... But the...
it's the sump itself thats stripped, I'd have to re-tap it and then go the next size up. It's really a toss up between a new sump (I have a...
While I am willing to sell the kit, I'd prefer a swap because I can't ride her totally naked. Got my water pump seal kit, installed it and it...
Don't like the look of it. kinda want to make this bike like my old one
So I want to get the OEM fairings back on my bike, but as it turns out the Tyga kit swaps a lot more than the fairings and a few mounting points....
You're in Sydney right? same guy that my mate bought that black and orange ZXR250 off with the busted sprocket seal?
Do you also have all the bolts and washers? and all the little fiddley bits?