Separate names with a comma.
if it was running fine when you rode back home and if it was raining while riding, check for soaked wire connection bullets . (wire cluster...
Are sure you are doing the bleeding properly man? "pump the lever 4 times, loosen the bleed nut and quickly tighten it while holding the break...
thank you very much for the advice sir. didn't know that It happens.
greyimport must be correct. I know From experience that Japanese bikes use interchangeable parts. even if the numbers differ slightly, they might...
thanks a lot guys . I tried everything . heating , wd 40 and they turned out but not completely so I had it drilled . luckily the pilot screws...
pilot screws are stuck on the left side carb. suggestions to take em out anyone / i dont wanna damage the carb body. Thanks in advance
thanks for the pic sir , just cleaned my carbs of the GSXR 250 gj72 . which is the same. this helps a lot
might be worn out brushes (contacts. ) cheaper to replace them
purchased it an repaired the mono shock =D then gave it a good welcome back to life ride