Separate names with a comma.
160km/h top speed isn't too shabby. The only way i managed to top that was down a hill and drafting a big bore bike. If i recall, with a downhill...
I guess my clutch replacement tutorial will be getting more use in the not too distant future. ;-) PS. Hai guyz! Yes, i still lurk around here...
You are indeed correct that after you give the bike a hard run the cooling system has to cope with increased heat load, which means the water in...
Well done Pesqueezo. For anyone else reading this thread in the future i believe the blinker canister is located on the left hand side of the...
She was hot. I already had her number as she was a friend of a friend i ride with. She also had a great tanky boyfriend who i was also friends...
Stick your head down underneath the bike and look for where the 4 header pipes come out of the engine and join into the collector box. If you can...
Slight movement is quite open to interpretation. If your talking a wiggle, then that's fine. If your talking a couple of millimetres then you...
As you've found out... you can use the throttle with just one cable but the second cable is meant to be there as a backup; both in terms of...
If your after a little bit more acceleration without sacrificing chain life then go up a couple of teeth on the rear. The rule is 3 teeth on the...
Wahoo! <!-- s:alcoholic: --><img src="{SMILIES_PATH}/icon_all_coholic.gif" alt=":alcoholic:" title="Alcoholic" /><!-- s:alcoholic: --> I'm not...
I believe that it's possible to take the forks from a TZR250. As for which model and the extent of the modifications required, i'm honestly not...
I'm not aware of any law/ADR that would stop you from painting your screen. If you do paint it, i'd recommend painting the inside of it not the...
Welcome to the forum PolyFZRrr! Congrats on your new toy; and don't worry about the little stop-drop incident. It had to happen atleast once, and...
That's a pretty decent speed run! Was that indicated or GPS? I'll assume indicated so take off a couple for over-reading. Still a very healthy...
Going from a 55 tooth rear to a 44 tooth rear will result in slower acceleration and in theory more top speed; BUT given the FZR250 can't hit top...
No one has yet mentioned that it may be the breather valve in the fuel cap. If the breather valve gets stuck or clogged then it doesn't allow...
I'd honestly just replace the whole shebang and be done with it. The difference between old ratty headstem bearings and nice new ones are day and...
Some good advice from _M_ on potential streetfighter paths. If you are serious about a streetfighter then i'd highly recommend building it up...
I can't recall exactly but on the FZR250 but on most inline-4 250's there's usually another bolt at the rear of the engine just infront of where...
As hawkeye suggested... if it's a matter of getting home and avoiding a trailer call-out then you can actually rollstart it in 2nd gear and then...