Separate names with a comma.
Thanks, but i'll pass on that. I'm really after a good set.
No, I already have one of these. It only came with the main sets. I need new needles and the tubes the slide into.
Does anyone know who sells aftermarket emulsion tubes and needles for the 3LN? The last set I got off yamama cost close to $400. And for tubes...
I'm looking for a set of exhaust headers of a 2kr. But I want the non-exup model. Its for a race bike that has already had the exup stripped out...
A mate got some off him for the CBRs, and they came in honda boxes. Will let you know how long they last thou. But considering the same pistons...
Turn it into a race bike! Seriously, if you have one that is collecting dirt you should turn it into a race bike. Clubsport lites/Formula 4...
Ever tried to rebuild one of these motors with parts from Yamaha? Well, it can get expensive. But now a guy on ebay is selling engine parts for...
Nah, the preload adjust didn't do much. I put in a shock out of a CBR600F3 with a 40mm extension plate. (Would have gone with an R6 shock, but...
I've seen new plastic fairings for these on ebay for $500-$600. Might work out cheaper in the long run
i got my chick strips down to 5mm (ish), but couldn't get any lower. The shock would bottom out and the foot pegs would scrape the whole way...
Did you ever find this out?
Re: Cylinder 4 - small end bearing Hey sim, just came across this its for the 400s, but it sounds like a similar problem. will keep looking thou...