Separate names with a comma.
My front brake is spongy. The rubber hoses look original, now 31 years old, so I will replace with stainless braided lines. I’m looking for a good...
Has anyone got a lower left hand fairing rear mounting bracket that they could photograph and post. I don’t suppose I’ll ever find one, but I...
I’m investigating poor cold starting on my 3LN1. There’s a small diameter tube that runs up the side of the carb, from the starting jet in the...
I now have my 3LN1 up and running, after an engine strip to replace the piston rings and shim the valve clearances. However, cold starting is...
The exhaust camshaft on my 3LN1 is bent, and locks up when I tighten the caps down. This is my fault, I was tightening the bolts in no sequence at...
Is there a file that I can look at to discover the tricks for inserting all 4 pistons into the barrel?
My 1989 3LN1 has a mounting grommet on each side of the fuel tank, where the seat fairing meets the tank. However there are no mounting pins on...
[ATTACH] [ATTACH] I'm checking everything, valve clearance ,valve timing because the bike has been stood for a long time, and I have no history,...
Where can I buy these Yamaha colours in the UK? FZR250R 3LN1 1989 Silky white Y1 - 901 Stripe Colour - Dynasty /Royal Blue Metallic Y4 - 958...
I need a pair of riders footpegs to replace the aftermarket ones fitted to my bike. Anyone in the UK got a pair? Jim