Separate names with a comma.
I've already done the valves previously. Many of them were so tight they had a negative clearance. I know when I set them some were still pretty...
I'm starting to think that sync'ing carbs is really not that important to just making the thing run at least modestly well When I first got the...
nope, still going flat. The weird thing is I started the bike a few days ago - didn't ride it just started it - and all was fine. Shut it off, 3...
Yes although both have 70,000km and 27 years on them so maybe they're worth replacing. Jets are cheap enough, but needles???
Have put brand new plug leads and caps on. Even put rubber lead separators on so the leads aren't touching any metal parts of the bike. Made the...
Hmm I set the valve clearances in spec not long ago.... And not the slides don't bounce around, they're very stable, but yes they all open
Almost there with the FZR250, final issue to fix is as the title says. Around the 7500-10500rpm range if i'm cruising and stay at a fairly light...
about 5 hours of riding time on it, so far so good. Looks like that was the issue as normally it'd go flat in 2-3 hours
All I can say is WTF! So I completely dissected the wiring loom, couldn't find any issue. Tested continuity on all relevant wires and that...
I did install an LED bulb in the tacho backlight but thats it. Doubt it would cause that much of an issue. Thinking through it more I reckon I...
Have measured amps with battery lead disconnected and hooking multi-meter between the battery and disconnected lead. With the key OFF there is...
The short version is this: I can ride the bike for a few hours then the battery goes flat. In addition to this, my brake light seems to be...
Those are some pretty rough looking carbs.... I ended up getting another set for the butterfly valve, not a bad idea that I did because I swapped...
Thought it important that I post an update to the above. I was using short bits of radiator hose and clamps to get by, but I did eventually order...
The one I made starts from a waterjet cut template. It's starting point is much closer than you'll get from cutting it out by hand. And it is 95%...
As the title says pretty much. I know the 3LN and 2KR carbs are different, but are they interchangeable between bikes? Mines a 2KR and i'm looking...
So after the last post I had coolant leaks and an electrical problem. Still chasing the electrical problem but I did fix the coolant leak. After...
The Long Story: (Might help someone in future) So the first attempt just doing it by eye was crap, idled way too high. Second attempt I bought...
Did you put a taper on the edges of yours or just get the edges the right dimensions? I just reassembled and noticed that ALL of the butterfly...
Finally got the brass and finally got it cut with the water jet machine. It was a bit tricky, he drew up the dimensions with an oval shape that...