Separate names with a comma.
I reckon the shed is one of the most dangerous places for motorcycles. Today I worked hard to ensure the girls blouse on my tyres is even and...
Top effort champ, I also tip my hat to you. Thanks.
Those wheels are sweet, mate, and you'll have a real hoot with the bike.
He's not that old, but who knows? I healthy diet and clean lifestyle supposedly do wonders for the seven signs of ageing...
Hi there, I bought this in from the Americas to put in my '90 Across after reading somewhere that it'd fit with some modification to the screw...
Well done so far! You'd be pretty giddy with anticipation and excitement for sure.
Hi Lynxdragon, I noticed these on page 116 of issue 304 of Motorcycle Trader. They're available from www.Zorros.net.au for $199.90. My wet-weather...
Yeah that looks like a lot of left'n'rightn and I expect would barely warm the gixxer bubs up. Some drivers are shockers, but after a while...
I've recently begun work in Altona North so fortunately haven't had to endure the bridge (or the freeway) since late March. I've hit the bridge on...
Is it too early to be donning the Winter gear already? This mornings commute was a little balmy compared to yesterday morning, but coming home...
The Across uses two Mikuni BSW-27 carbs which have pilot mixture screws just forward of the diaphragm caps. The factory setting is 1.5 turns out...
Hey Zook98, that's the cam-chain tensioner assembly (see attached?). They're non-adjustable on this bike, and the rubber bung is there to keep...
Look at all that seductive Hamamatsu alloy. MMMmmmmmmm, mmmmmmmmm!!!! They're quite a neat little unit!
I'm not sure, but there isn't any offset on it. I installed it with the stamping outfacing, but dimensionally it is even. I've had fronts before...
Good on you, Kiffsta. I suppose it's time to bring out the brickies line then, hopefully the frame's still straight...
'90 in Lavo, Melbourne.
I considered it further and realised the offset should run to the outside. If it didn't then the rear sprockets alignment would vary depending on...
On all previous bikes I've run the rear sprocket offset to the outside, is that still the case with the Across? I'm positive the manual doesn't...
Thanks for your interest you guys, there are heaps of cool things the X913 could have but the factory (moreso the accountants) ruled out. The...
Hah hah, of course, but you're buying the rum!