Separate names with a comma.
Being the drill bit needed so thin, it bends and jumps off, hitting the walls. It's not noticeable in the pictures but the screw didn't snap...
Hi All, I'm after one single carburettor for the ZXR I've been restoring for almost two years now. As it's been going on with it, every time I...
I BLAME GIGI D'ALIGNA FOR THIS!!
It’s a sort of a hex screw, not torx, it’s so tiny that I fear I’ll make it round if I push it too hard. If I take it out I don’t think I’ll be...
Wanted to clean/polish the triple clamp on the ZXR and found this security bolts. Any idea on how to work on them? [ATTACH]
Got the wheels and the calipers back from water blasting, wheels headed to powder coat, calipers painted myself with VHT. Struggled to find...
Ok, it took me a while to understand the hose you were talking about and it does as you say. The mistery continues...
Wow, that's quite low! I'm 75kg and I was advised by the Dunlop guys at Broadford that I should be running with 32psi front and 36psi back.
Hahaha ok ok, I get the metaphor! Yea, it’s a constant dribble, not drops. Also steady flow from the tank. Next thing, vacuum valve which, other...
Took the carbies out, set a bucket under them and followed Murdo’s instructions. All carbies bled half a litre or so of petrol, a constant drip in...
Will do. Thanks Murdo!!
Mm ok. Would choke help with that? Now it won’t even idle, throttle just stalls it and the only way to rev it up is choking it.
At times. If I leave it idling for a while and then open throttle it will, but just once. A couple of minutes more and back again all good. It’s...
I’ve changed the reg/rec on the ZXR, the reading on the battery was way below 13v, and the voltage off the alternator was a healthy 25v @4000rpm...
Welcome!
Atrocious! went straight to eBay
Thanks Linkin, I'm after some new clear screen here, either with bubble or without it. Current one is in very bad condition.
Alphas are insane Sent from my iPhone using Tapatalk
Yeah that's the plan, reset all of then now that we're at it. Will follow your experience and set it up to the upper. Cheers!
Cracked open the ZXR250 engine, it's valves' time. 13 out of 16 were off specs. Quite nerve wrecking but pushing thru thanks to a friends...