Separate names with a comma.
So finished the cosmetics, now to play with the carbs jets... Again. [ATTACH]
Right! I reckon everyone's have just disintegrated over time though ;) Manual wouldn't mention it for no reason. Yes there is a seal over it, but...
Yeah interesting... but o-rings are shown in the service manual. When the carbs are up the right way these cylinders could cause a significant air...
You selling or showing me I need to order two for you too Grey? ;)
Yeah looking at it again I see that now. Bike was running fine(ish) without it but will try a couple of 13374-35C00 anyway!
Well I've ordered part 22, whether it makes a difference or not will be found out shortly. Dont think it could be causing a rich condition safe to...
If I take out the silver cylinder the hole runs straight into the venturi (venturi?) - the main air tube through the carb. On the bowl is nothing!...
There's a bit of an impression on the gasket from when it has been pressed into place, against that hole. Can't see any residue from a previous...
Hi guys, now I've had the bike running ok for a while I'm putting more time into restoring her... cleaning up the frame, new seat, fixing wiring,...
Thanks all, I think I'm 99% there with the setup now then!
Right, yes, for mains alone you read the base of the porcelain, we agree on that! I was then seeking some help with determining if the idle...
Ok, I was just going by this picture that I could ascertain the idle mixture: http://www.crankshaftcoalition.com/wiki/File:3.jpg
Right so I do have to do a plug chop. Ok well I replaced the main because it wouldn't rev above 5k so now that issue is fixed I probably need not...
Ok so brand new plugs and the result after a couple of power runs to 7k: [ATTACH] What's the verdict? Right cylinder a bit rich at full load?...
Gave that all a clean and she seems to be all good now! The larger ball bearing's chrome plating was everywhere so that must have been the cause....
This is my cap so I hope its in there cos I'm not aware of anything going out the bottom of the tank. [ATTACH] I'm assuming this is the...
Legend, she runs the same as off the bottle from the tank without the cap! So it's just a matter of disassembling the fuel cap and checking for...
No, so try with the fuel cap off?
Right so the final issue I'm struggling to resolve is one that's come back to haunt me. She runs fine from a bottle still, but from the tank not...
Yep, cool, was just wondering why you couldn't do it in first or second. So that method of testing I've read can be used to read the mixture...