Separate names with a comma.
Update: A bit of Teflon lube made it seat much easier and it isn't popping back out. They are very snug orings!
I used just regular assembly oil on it. I'll see if I've got any silicone or ptfe lube in the garage
It fits on the brass piece perfectly and doesn't look over/undersized. It's just a bit of an effort to get it on. I'll measure it up when I get...
Quick question chaps.. I'm in the process of installing the seals, and have query about the float needle/fuel filter seal. With the new green...
Thanks guys. I'll be stripping the carbs down soon as my litetek kit arrived. Fingers crossed it solves the issue!
hi guys, slowly managing to get this little bike back to its best.. When I bought it, it was running poorly and it turns out that the previous...
Yeah, 1+4 operate the fuel tap, 2+3 go up to the vac valve and the 2 carb vents on the top also run to the valve. Which then runs to atmo and the...
why would i run the vac lines to the airbox? wouldnt i just block them off?
I have a question that I’ve tried searching for a definitive answer, and can’t find one.. The vacuum valve thing up by the headstock – what...
There's 2 on eBay at the mo. One is cheap but quite rusty, the other is about 100 quid in better condition.
Thanks for that, I'll get onto him. I've ordered a set of your seals actually, i hadn't realised you were an active member on here!
Morning guys, Been lurking about here for a few weeks trying to get some info before buying my '92 ZXR250C and thought it’s time to say hello how...