Separate names with a comma.
Man, what did you use to get such an awesome polished finish with such bad deep etching?
Yeah & the bike without its sting on sure looks like a pretty little savage Wasp, I love those wasp colours. Very well done job.
Maybe Iv'e got it wrong murdo, in fact placing the point of contact further back would require more horse power to lift the machine from contact...
Just a question in interest, why have you made the drag bars so long? surely if they go back so far the leverage power would actually lift the...
Now that last pic of a lovely GSX 250 shows how much shorter the tail end of the seat looks with the original rear mudguard fitted, love that...
Once again, I can't emphasize how important & informative spark plug READING is, it will tell you exactly how the engine has been running...
Yes I know, I know, the only reason I replied to the earlier thread was because it may help some poor soul that has neglected such a simple thing...
The plug you show in the photo is stuffed, if the porcelain part of the center electrode has gone black it has become carbon shorted, hence the...
I agree with Cuda on this issue you have, the carbs will probably have to come off again unless you can remove the bowls without doing so. However...
No, the NZ 250 was a single cylinder DOHC 4 valve bike producing 31 bhp @ 11000 rpm. They were only produced for a few years between 1984 -87. All...
Just don't be to sure, have you ridden your little under powered 17 hp SRX 250 yet, he he, the same applies to these wonders, the power to weight...
Original parts can some times come very expensive, especially when it comes to the simple ol nuts & bolts, go to a local fastening specialist &...
Totally agree with ShaneP, we have been selling Chinese engines etc for going on 10 years or so, nothing wrong with the engines, but unfortunately...
Agree totally with this post, beauty is in the eyes of the beholder. Just have a look now at how many bike manufacturers are now offering Cafe...
You mean 120 mph not $1.20 dollars. cheers.
No, I got the parts I needed very reasonably priced, unfortunately an over sized piston would not have helped as the piston was so badly seized it...
Go an have a couple of beers, NZ ones of course, I have just had the same depressing problems with my Yam SRX 250, I had just got her up an going...
Just going back to the problem you had with replacing your fork leg seals, I had the same problem with my Yam 250 SRX. It failed a WOF ( if you...
Hey all the best with your bike, I totally agree with the advice you have been given over the brake problems, I know now you have had to pay for...
Beautiful paint job on a beautiful bike.