Separate names with a comma.
Chug mode has returned. :/ Float height seems to only stop it from doing it as often, if i go too low it starves it of fuel altogether. To recap....
Same here. Harley softail. I mean, yea I'd have one over no bike at all but it aint for me
Its all totally stock. This bike actually belongs to my house mate. She's decided not to take up bike riding and just wants it sold. To that end...
So. The erratic idle is fixed. I had clip on the carb rubber come loose. I've replaced them all with new hose clips and have a good seal now....
I had wondered, being a 'pilot' jet adjustment, what it would do at WOT.
I'm about 1mm above that now.
Vacuum leak was my first thought on that surging idle. I'll test tomorrow. Yes, flat at WOT. So I'll try a little richer. -After I sort any...
Floats set 'too' low. (Or lower than i looked up they 'should' be. Just a puffteenth of a bee's dick. No chug mode :) 3 laps of the block...
Stripped and dismantled again. Thise needles are near perfect, shiney. Tubes look good, even under a magnifying glass. This does not mean they are...
Bearing in mind I have stripped, cleaned and rebuilt these carbies twice and didn't see any obvious wear. But then i wasn't looking for miniscule...
So I get new emulsion tubes? Really appreciate all the help guys. Meanwhile..out of interest.. My ZZR600 developed sympathy pains. Ha (I'm...
Yes. I've discovered that shutting the fuel off seems to make it come back quicker
Hey guys.. look Https://2fiftycc.com/index.php?threads/1990-gsf250-bandit-troubles.3568/ (Hope that link works, just copied and past) So..it's...
I have it plumbed in like the diagram, but i don't have the little tubes that go to the overflows (under bowls, 34 etc). Not needed though I...
I've given up for today. I've still got it in my mind that this is electrical. It just feels it the way it just cuts to 1500rpm like that.. But...
Yep still being very odd. :/ Starts fine and will sit there and idle all day and rev up sweet on the throttle. You can click into all gears on...
ITS GOING. :) So I fabricated a leak down test by fitting the hose of the compression tester to a small compressor. I then put each cylinder in...
I don't have access to a leak down test unfortunately. Valve clearance not adjustable? Call me stupid but there doesn't seem to be any adjusters...
Compression test done with carbs off btw.
What the actual!....??. I went and got a compression tester. Compression test gets 30psi on all four pots, 35psi wet. Exactly the same on all...