Separate names with a comma.
Sounds like a plan.
Which matches what the engine number on the info you posted. I should check things before I post. :)
But mine is a '94. Maybe someone put the wrong jets in it after reading the '03 specs. The specs in the manual for the zxr250 Say 122 and 125....
The wait was pretty reasonable considering I didn't splurge for an Express option. And I also had full tracking to my door. They're great quality...
So just an update everyone. Bike is back up and running. Carbs were soaked in solvent and finished off with a soak in engine conditioner. All new...
All the rubber parts are getting replaced ( o rings ) and all the non metallic parts are in separate tubs. But i have a long time to wait for the...
Ahh thanks man. I actually remember seeing that when I was splitting the bank now. Anyway carbs are having a refreshing Turpentine bath over...
Umm. Does anyone know where this little brass cylinder goes. It was randomly in my little tub with #3 carb. Didnt see it with any of the others....
[ATTACH] So all o rings and seals are ordered. Have you got a favourite carb soaker / cleaner that isn't $10+ a can ?
[ATTACH]Yes it was just the camera. Thank Christ for that.
[ATTACH] Well ive started cleaning them. [ATTACH] And I don't know if the seat are supposed to be this hard to remove, but man did this take me...
Ive always had to give it pretty much full throttle with full choke to get it to start. Maybe the previous owner changed the pilot jets. I set the...
No I did use the prime but definitely not while cranking. I guess the lack of fuel filter and possibly not getting all the rusty crap out of the...
Also while I hate to make myself look stupid by asking this but, as this is my first carby bike ( or any bike) is it possible the way I was trying...
[ATTACH] Hmm I guess the float needles may need to be replaced after all. All the plugs are out and ive given it a crank ( fuel went everywhere )...
Yeah i figured it would be something along those lines. Is there a way to test the temp sensor itself? I'm having problems with the idle. It...
Hey guys so i got to ride the bike today for the first time, after getting my learners over the weekend. Some things ive done since the last...
No, turns out im a newb & when I took the slack out of the throttle cable I took out a bit too much slack. And I do like the idea of mounting the...
Well it starts reasonably easy now. But once started it starts climbing in the revs up to about 8-9 grand. This has me stumped but I'll see what...
I did do the first check mentioned on that page and when checking from the white connector pin I had no resistance to any of the three phases. But...