Separate names with a comma.
I actually bought an engine to swap mine with and it turned out that the engine I bought had some oil stuck in the galleys that didn't come out...
Did that fix it? I just dumped out 600mL of oil and the bike runs perfectly, but it still has a lot of oil blow-by. The sump gasket was brand new...
Got the conrod while at work. This one seems to weigh 6g more and has no stamp - or a very light stamp that used to say B or E. Time to get thr...
I am fairly certain that @Linkin had the 3LN1 kit on one of his 3LN3-3LN5 bikes.
Time to revive a dead thread. I measured up a 2KR and 3LN conrod and they are almost identical aside from a 2mm difference in length and a 3 gram...
Not yet. I'll check under the starter gear some time. @Linkin I did the fingernail test on the crank and bores and they all feel fine.
I'll make sure to check.
That was right after I removed the burnt rod. I took the vernier caliper to it and there was almost no difference from the next pin. I made sure...
As far as my untrained eye can tell, it just needed a polish. If you spot something fatal then I'll just buy a new engine. [ATTACH]
@GreyImport How much would you let that go for? I still have the old conrod but it looks a bit toast. [ATTACH]
Any that you can fastmail to NZ?
The engine rebuilders said my engine looked good and said it's not honed out enough for oversize. I noticed the lip on the bores, but I suspect...
I went to my usual workshop for the FZR (which seems to be the only place open on Sunday) and while they had 2 FZR250s in there, they had no...
[ATTACH] [ATTACH] [ATTACH]
I tried doing them by connecting to the conrods first then slotting the chambers over them while compressing the rings. My #4 cylinder was seized...
Alright, thanks ! Back on the hunt if anyone has a 3LN conrod they can spare. I didn't measure exactly how shorter the 1HX rods are, but they...
I got another B-stamp one and I'm *hoping* the shorter conrods cause no issues. I am also hoping it will act like a stroker kit for the inner 2...
I am currently rebuilding the 1HX engine out of my 3LN3 FZR250R and need one good condition conrod to match the rest. I have tried all the...
@Linkin I got the aliexpress pistons and they weigh 3g lighter than the factory pistons. Also I could only source 2KR engine parts and their...
I forgot to follow up this post, but it was #3 conrod - big end bearing. Inside the bearing is some bronze/copper than got squashed out.