Separate names with a comma.
Has this one been here yet? [ATTACH]
I've just ordered up some aluminum folding footpegs that'll mount at the location of the stock mounting bolts, & not reach forward 4 inches like...
EBay purchases are arriving and I'll be assembling my front brake system soon. I've got stock CB750 Nighthawk 91-03 Caliper, new seals if...
Just a small update today. I tipped Nighthawk #2 over to have a look at stealing its kickstand, as it turns out the kickstand on these bikes is...
Cool, I was wondering if they'd be bright enough for daytime use.
As it turns out I did grab the brake pivot and actuator rod from the 750. Today I added the cheapest Chineseium LED turn signals I could find,...
This afternoon I went out and spent some time with this bike before I ran out of daylight. I swapped over the handlebar switches, throttle tube...
Hey neighbor, welcome from Boston.
They have a pretty good library of manuals over at www.vintagehondatwins.com
Still unable to locate the box of parts for this bike, today I hauled a partsbike home from storage to swap over the wiring, airbox, kickstand and...
That reminds me of my former 1981 CM400C that had two separate springs in each fork. I added 20mm spacers on top but never did add any air...
I've always had good luck increasing preload by 12mm to 25mm increments, PVC pipe is still cheap. I've used bronze bushings, stacks of washers and...
Tuesday, an update but little progress. I installed the EBay fuel cap and sat the tank and seat on the frame. Fork ears are 3/8" from the tank at...
Ok, Friday's update. I was able to do a little assembly this afternoon. This is a CB750 headlight with some fork ears I made in 2008, all painted...
Thanks Murdo! Looking at those 2 wide photos I've been thinking of the nearly 140mm of fork travel and how those gaitors are likely a limiting...
Tuesday's update. Sheltered from direct rainfall I was able to pack the tapered rollers with grease and install the triples for the last time. I...
Hey there Bill, fancy meeting you here! Sounds like you're getting the right kind of help with your spring search from these fine Gents.
Steering stops are in, they're about 1.5" high and should do fine, too dark and damp to put it back together tonight. I used 5/16-24 grade 8...
Before [IMG] After [IMG] [IMG]
Ah. 69 degrees and 53% humidity. I found the Rustoleum 7887830 Stainless Steel Appliance epoxy paint that I picked up this summer and started at...