Separate names with a comma.
If you want a bike that is not hard to find, not terribly complicated, fun to ride and a reputation for being reliable it is hard to beat a Kawi...
My friend put a 2011 CBR150 motor and ecu that he purchased through Tyga in his and we were pretty much equal. We did a couple of 1000+km camping...
I bought my 125 new in 2007 and have put over 34,000 kms on it. Twenty three thousand of that is with a 166cc big bore kit. After 50 years of...
Running in cold weather can let condensation build up in the oil if the engine doesn't get up to operating temperature. I suggest you wait until...
I ordered the shims I needed from my local Suzuki dealer, using Suzuki part numbers. They where used on other models available in North America.
I live in a hilly area and park in 1st gear when the ground is not flat. Also always start bike when seated with clutch pulled in. Still regret...
I have used Caswell and Por15 with good results. You have less time to play with the Caswell but it has a nice finish. Por15 can be bought as just...
Happy Canada Day
It has been along time but I thought I would update you on the outcome. The bike ran fine after assembly and was much more responsive. I believe...
Most of my OEM parts are from Impex Japan, Wemoto has a few things as does Webike in Japan. I have bought used parts off Yahoo Japan. Carb seals I...
My rings showed up yesterday(Friday) afternoon so I spent the evening assembling the engine. Today it was installed in the frame and I fired it...
I followed the instructions in the Across manual because I cannot read Japanese.
Thanks for the link. Correct me if I am wrong but a look at the coils indicates that the plugs fire slightly before TDC on every stroke so the...
Thanks Simon. Yes sixteen pins between arrows. It didn't run so I have it all apart again to try and figure it out. Also waiting for another set...
[ATTACH] After boring it .25mm oversize and installing new pistons and rings I assembled it with the cams installed how they were before taking it...
I couldn't find pictures for this engine so could someone let me know if my pictures look right. The picture of the crank did not turn out good...
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]
I was just wondering if you got the bike up and running and if so how did the Chinese pistons work out? I think I will need to get oversized...
Thanks Simon. I tested the engine cold because it takes so long to strip the tank, fairings etc to get at everything. The carbs where removed so I...
Hi Simon If you use the carbs from your other bike your bike may run rich but at least you will see if it runs consistent and isolate if the...