/ Register

  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Help Tank grip - where do you get yours?

Discussion in 'Riding Gear - Accessories - Workshop Tools' started by Linkin, Aug 26, 2015.

  1. Linkin

    Linkin The Mechanic Premium Member Contributing Member Dirty Wheel Club

    Messages:
    4,733
    Likes Received:
    2,874
    Trophy Points:
    943
    Joined:
    Mar 18, 2014
    Location:
    Sydney NSW
    My Bike:
    FZR250R 3LN6
    I'm trying to find something like stompgrip or grip pads to use on the fizzer tank, and it's a bloody headache.

    I'm searching ebay for things like stompgrip or tank grip and you cannot find anything in Australia that is cheap enough, and I don't want to wait weeks for something overseas either.

    I've thought about going DIY and had skateboard grip tape in mind, but thought it may be too rough on riding gear.

    Anyone else done this? What did you use and where did you get it?
     
    Linkin, Aug 26, 2015
    #1
  2. Aufitt

    Aufitt Active Member

    Messages:
    117
    Likes Received:
    134
    Trophy Points:
    88
    Joined:
    Jul 6, 2015
    Gender:
    Male
    Location:
    W.A.
    My Bike:
    Z50 CB125 RZ500 MC22 R3
    • Like Like x 4
    Aufitt, Aug 26, 2015
    #2
  3. GenericForumName

    GenericForumName Active Member

    Messages:
    73
    Likes Received:
    104
    Trophy Points:
    148
    Joined:
    Jan 20, 2015
    Location:
    Hobart, Tasmania
    My Bike:
    FZR250R 3LN1
    Bad photo, but I use a sticky foam pad. It's the same stuff I use for my seat pad but a smaller thickness.

    Any good foam or rubber shop should stock something like it. This cost me $17 for half a square meter. Which was enough to do a seat and two sets. Just need to cut it out with a blade then go around the edge with a dremel or other sander to round off the edges.


    [​IMG]
     
    • Like Like x 5
    GenericForumName, Aug 27, 2015
    #3
Tags:

Share This Page