Separate names with a comma.
Unsure whether anyone had obtained a wiring diagram yet. If not I have photocopied the page straight out of the genuine service manual and thought...
Long time no post. How's everyone been? I haven't done much work on the Zeal since I finally go the bugger running properly. But I have obtained...
[ATTACH] Problem solved. Ended up being these adjustment screws on the carbies. Runs like a dream now and even easily got her up to 120 and it...
So checked cables they are defiantly connect correctly, tried another test of removed both cables from the handle and started bike of which is...
I'll give these all a go tomorrow and report back.
So is the bent on meant to be closest to ride or other? I never removed the cables from the handle bar so the bent one is in the throttle open...
With engine off throttle springs abck perfectly fine as well with the certifying click it makes upon return. Will disconnect return tomorrow and...
The throttle its easily has 3-5mm slack as to the specs
So after finally getting butterfly rod straight and carbies all back together I have now encounted another issue. If you hold the throttle firm...
Fair enough no idea why i thought they were different carbies for. We barely if if the screw driver removing the screws which is why we're...
No they used the 25s on the Zeals. I have wondered about useing the FZX250 carbies and wether theyd work on a Zeal.
Hi guys, Finally rebuilding the Zeals carbies and had to butcher some screw due to their tightness. And in the porocess warped the rod that run...
Incase no one has seen this yet I just stumbled upon this...
So found out today. One of my carbie pilot screws is leaking -.- Might be time soon to get all the litetek seal kits and replace all the seals....
So put the bike in to get tuned last week. Have received it back it's running the best it ever has, and goes above 100 now. Jets were up sized...
Also in regards to keeping water out and away from my plugs do the SD05SF actually seal the plug hole up properly or is there gaps around the...
So after reading them (correct me if i'm wrong) so a spark plug dampens so much of the RFI but not all of it so the caps block the rest, so that...
Also updating found greys FZR build thread with the link to new caps etc but noticed they are 5k resistance, Zeal spec sheet says its a 10K though...
Do after market plug caps exists for the FZR and Zeals? If so where can one obtain them and what specs does it require? Mine aren't sealing...
So finally got some spare change and time so finally putting the bike in for tuning this week. Hopefully break that 100kph threshold.