Separate names with a comma.
My front brake is spongy. The rubber hoses look original, now 31 years old, so I will replace with stainless braided lines. I’m looking for a good...
I had the same problem with my 3LN1. 33000 Km. it would not start. Compression check using Gunson comp. tester and adapter 10 mm Dry bores. 8...
Yes, that’s the one. Thanks
Has anyone got a lower left hand fairing rear mounting bracket that they could photograph and post. I don’t suppose I’ll ever find one, but I...
I’m investigating poor cold starting on my 3LN1. There’s a small diameter tube that runs up the side of the carb, from the starting jet in the...
Yes!
I now have my 3LN1 up and running, after an engine strip to replace the piston rings and shim the valve clearances. However, cold starting is...
Thanks, I double checked everything and found that I had mixed up the caps.1 inlet and 1 exhaust interchanged. Changed them over, no problems....
The exhaust camshaft on my 3LN1 is bent, and locks up when I tighten the caps down. This is my fault, I was tightening the bolts in no sequence at...
Thanks. All sorted now, using your method.
