/ Register

Recent Content by dustyjax

  1. dustyjax
    Post

    running problem

    hi just an up date, I have the bike running now, thanks to all your input and help, cheers Mike <!-- s:Biker1: --><img...
    Post by: dustyjax, Jun 11, 2011 in forum: Yamaha 250cc In-Line 4's
  2. dustyjax
    Post

    running problem

    thanks Dave, I have noticed that I have piting on one of the needles that goes in though the DIAPHRAGM where can i get a replace ment one from,...
    Post by: dustyjax, May 23, 2011 in forum: Yamaha 250cc In-Line 4's
  3. dustyjax
    Post

    running problem

    hi snowfox, I read that somewhere on here and got me thinking. going to change the plugs and see how she goes then. cheers mike <!-- s:Biker1:...
    Post by: dustyjax, May 23, 2011 in forum: Yamaha 250cc In-Line 4's
  4. dustyjax
    Post

    running problem

    hi I have been reading some posts on this forum about spark plugs, I couldn't get CR8E plugs only Cr9e would this also be a cause of the...
    Post by: dustyjax, May 23, 2011 in forum: Yamaha 250cc In-Line 4's
  5. dustyjax
    Post

    running problem

    Hi guys, I got a secondhand set of exup cables and they all work fine now set the valve as per other posts about it. I am going to look at the...
    Post by: dustyjax, May 21, 2011 in forum: Yamaha 250cc In-Line 4's
  6. dustyjax
    Post

    running problem

    thanks mate check that tomorrow, the mixture screws are stuck, tried turning them just before. Think this bike has been sitting for some time,...
    Post by: dustyjax, May 20, 2011 in forum: Yamaha 250cc In-Line 4's
  7. dustyjax
    Post

    running problem

    hi again I have pulled the carbys apart and cleaned them, lots of crap in them. got the bike started but the problem is still there. Would the...
    Post by: dustyjax, May 20, 2011 in forum: Yamaha 250cc In-Line 4's
  8. dustyjax
    Post

    FZR 3LN 3,5,7 Parts on ebay - SOLD

    Re: FZR 3LN 3,5,7 Parts - Going to Ebay Unless you grab them hi mate do you still have the carbies and how much you want for them? cheers mike
    Post by: dustyjax, May 16, 2011 in forum: FOR SALE
  9. dustyjax
    Post

    running problem

    hi mate, just changed the fuel filter again now there seams to be full of fuel compaired to the last one which was a new one 2, the air filter is...
    Post by: dustyjax, May 12, 2011 in forum: Yamaha 250cc In-Line 4's
  10. dustyjax
    Post

    running problem

    hi mate, put undid the screws at the bottom of the carbies and got the same amount out of each one. took it for a run and still the same but I was...
    Post by: dustyjax, May 12, 2011 in forum: Yamaha 250cc In-Line 4's
  11. dustyjax
    Post

    running problem

    thanks mate, The first one when It stalls and wait for a bit it starts up no problem. for number 2 will try that tomorrow, I have let the bike...
    Post by: dustyjax, May 11, 2011 in forum: Yamaha 250cc In-Line 4's
  12. dustyjax
    Post

    running problem

    Hi Dontz125, No haven't pulled carbies apart yet was the last thing I wanted to do until I was 98% sure it had to be done. The slides move when I...
    Post by: dustyjax, May 11, 2011 in forum: Yamaha 250cc In-Line 4's
  13. dustyjax
    Post

    running problem

    thanks for the reply Snowfox, when I am in first and I let the clutch out and I rev it to change gear it starts to cough and spit than stalls...
    Post by: dustyjax, May 11, 2011 in forum: Yamaha 250cc In-Line 4's
  14. dustyjax
    Thread

    running problem

    Hi I am new to the site and new to motorbikes, I have just brought a FZR250 1990 3LN import and the guy I brought it off said that the carbs need...
    Thread by: dustyjax, May 10, 2011, 27 replies, in forum: Yamaha 250cc In-Line 4's