Separate names with a comma.
yeah thanks for that i'll give that a go once i get the cooling system sorted out. the seal in the water pump is mechanical, i.e. you can push...
replaced the water pump seals and took it a run, revved it to 17k to see if changing the plugs helped then at the next junction i seen the water...
i've got a 3ln and i've just been getting it in running order again. I manged to get it all working after replacing a few gaskets and o-rings etc,...
yeah i thought about the choke initially but it's fully operational and closing fully, i've had the carbs off to check the inlet rubbers just in...
my bike was revving pretty high once it gets warm with no load on the engine i was just trying to figure it out but i was looking for a diagram...
picked up a 3LN recently and i'm just going to strip it down and fix anything wrong with it i can see. the fork seals are shot so i bought new...