Separate names with a comma.
I have two of those cheapie direct drive ones. They seem to work well and have enough output to feed a small spraygun. Get the one with the best...
Don't know where you are located but here in Tamworth it has been over 35c most days for the last three months and I can leave my bikes for a...
Two problems here. 1 fuel not in bowls, where is it going? Are there any leaks around the bowl drain screws? Are the seals good? Is the engine...
Sweet bike. :thumb_ups:
Make sure you take the polish off those can lobes with some 100 grit sandpaper before you use the cam. Why, so that the small scratches catch and...
Admitted to myself that I will never get this bike to the salt lakes so put on ebay. Has now gone to live at Yamba, NSW and will be prepared and...
Manual says 'floats cannot be set'. Sounds like a challenge to me. :D What about heating the plastic float arm and bending to correct height. What...
Depends on how often you want to change seals. It only takes one deep pothole where the seals go over the rusty bits and your new seals are...
Go back to the stock jetting so you have a starting point. Some aftermarket exhausts work better/flow better than stock and need leaner jetting...
:welcome:
Lot of life left in that clutch basket yet. Nice work on the engine. Bugger about your tools.
Unable to find a centre stand worldwide, I used an old CB250 one that I had put away in my shed. [ATTACH] Had to slice it down the middle and...
Looks like it could be on backwards too.
Except that it is not a 400EX, that is a quad bike. VTR250 shown in advert.
Turn the crank around until the cam lobes are pointing up away from the valve on each cylinder then check clearance.
