Well done. I see that you decided not to replicate the tricky bit of detail on the end. A bit of sealant will be needed to keep it in place. Did you replicate the tapered bell mouth? What material did you end up printing in?
I use PLA filament but printed it using vase mode. Gives a thin flexible wall. Plan is to use a sealant at final fitting stage. Recreated the bellmouth and taper fit for airbox end. Wait and see if works now.
Welcome aboard mate. I'm a newbie myself still learning a lot. Can I ask where you got your aftermarket fairing from? And if it's turned up already, how is the fit?
I got fairing from MFS. Fit is reasonable you just have to work your way around it. A bit of shrinkage and about half the weight of OEM. Will post pictures shortly.
Carbs cleaned and new LiteTek kit fitted. Airbox seals done. Started first go. Shame the new fairing doesn't have the duct for the cold air to the airbox. We will see if it affects performance.
Thanks mate, much appreciated. I didn't mention, my bike is an FZR250, was hoping wherever you got yours would have a set for mine, but MFS don't, just bits and peices. Thanks for the info though