Separate names with a comma.
Hello all, I followed the advise of those members kind enough to share their knowledge regards the starting problem . I have purchased the...
Thanks again Glen for all the info. I have just ordered the jets through Hatrick , 4 x #12.5 and 4 x #10 . I will measure the remaining jets to...
Thanks Danno I will take your advise and check them. Bago
Thanks again Glen for your thorough and time consuming (yours) assessment. I will go down the pilot jet path. What size would you recommend
Ok thanks guys, I agree with your diagnosis, so I am presently trying to source some carby rebuild kits. Unfortunately Mikuni don't seem to...
Hi all, Finally found the time to try out the bike on the to road. Firstly set carbs back to factory setting and balance same once again , set off...
Thanks again for your help mate. Bago
Sorry about the delayed response I have had a few things other than my bike woes to deal with today, so yes the standard airbox is fitted and well...
Thanks Ruckusman for your suggestions to the problem. With your comments in addition to Linkin's I have at least now got quite a few areas to...
Thanks mate for the reply I'll check out your suggestion Bago
Thanks Linkin for your reply, compression checked on warm engine , results all cylinders around the 150 mark. I have checked valve clearances...
Hi all, After a lengthy engine rebuild, rebore , new pistons and rings ( 0.5 o/s ) new valves including seat grind and lap, new valve stem...
Thanks mate for your input toward solving my problem. Many thanks I will let you know when the puzzle is solved. According to Linkin there a...
Thanks for the reply mate and yes I agree it's a puzzle that's for sure. I haven't yet split the crankcase but it is on the to do list. I will get...
Hi all , I am new to this posting threads etc so a little help from the experienced is appreciated. I am currently in the throws of overhauling...
I have tried most of the suggested sites without success , ordered one through CSMNL waited 3 weeks and then they sent the barrel gasket instead!...
Hello all, I recently unwittingly purchased a Suzuki 1989 gsxr250r GK73A with only 27000k showing. It was a little knocked about, you know the...