Separate names with a comma.
What kind of voltage should I be getting between stators? Also, I'm pretty sure I'm not getting enough voltage to charge the battery, and I get...
Just took a video of the voltage while idling... [MEDIA]
Just swapped #3 and #4 plugs, problem seems to have gone away for now. However, I was looking at my multimeter and the battery voltage, with the...
The lead is conducting fine, the spark plug boot has a tear in it, but still conducts fine... I think I'll check if the plug sparks good in a moment
Sounds like I'm going to be busy in the near future with the valves! Also, it stumbled and wouldn't run properly (presumably not firing on #3),...
Silly question, how do I check the valve clearances? I've only really done engine work on a little 2 stroke before, so I'm pretty new to 4 strokes. :)
Oh and also, are there any rear sets I can put on? My left one is pretty badly mangled...
I had to separate them so I could change all the O-rings and gaskets to the Litetek ones. It runs a lot better after changing them over, a bunch...
Thanks for that Would you happen to know how I can separate the carbs? They're well and truly stuck together, and nothing seems to get the damn...
Found out what was leaning it out: the float valve needle was stuck in the closed position, so very little fuel was flowing to the bowl. Does...
I'll try that with the carbs, I'm gonna take them off because it seems to be running hot from being lean. Here are some photos of the plugs,...
Right I need help with my ZXR250C. I know my carbs need new seals, going to buy a Litetek kit next chance I get. I need new float valves and...
Thanks for the info Grey!
Hello! First post from me :) So, I'm wondering what's a good replacement chain I can get, and what sprockets do you guys recommend (like how many...
