Separate names with a comma.
Well that was short lived. I wrapped up the harness annnndd it stopped working again. So then I unwrapped the harness and tried to see what the go...
So I got the indicators to work - finally. I started to trace wires manually and realised that on the "new" relay I picked up that the positive...
Well as anyone would expect, the bike is a can of worms. Frustratingly, the rear brake light wire is green, just like the earth wire. The positive...
Hmm, I was scouring CRFs Only for informtation... only. Well I knew it wasn't OEM Honda but they do sell them from the Dealers.... so you'd think...
I must say, I feel like an idiot! So, it seems like I was just confused about the additional wiring loom. Normally on Hondas they have different...
As I suspected, here it says it needs hi/lo beam:...
I just have a quick question: To get a safety cert in QLD, do you need high / low beam? ------- Backstory: Recently picked up a CRF450X which...
So on YouTube there is a dude called Cameron Niemela who does pretty good bike builds. He has a wrecking business and cleans the parts to be...
I don't think so... It's not illegal to take a photo of anything if you're on public land or your own land (unless it's like, child porn or...
Well as usual I am currently working on the 450X now... But still keen to get the NSR on the road. I am working heaps over Comm Games so I plan to...
On Monday I bought a new bike for the trails, an 08 CRF450X. As much as I like Honda, they seriously lack in the enduro bike department with the...
I'm interested - I will get back to you soon.
ZX14 - Close enough I suppose although it ain't red!
So I'm now thinking gas is the way to go, but I think I'll still try both for some experience. I know my mate welds with gasless wire and has...
Thanks for the comments everyone. Supercheap has a deal for a Cigweld 130amp MIG for only $277. It seems like a good deal. I'll definitely get a...
So I have a few welding projects on the cards: Modify a KX125 expansion chamber for my CR125 New fuel tank mounting tab on my NSR250 thank Ladder...
On every bike (Honda) I've taken a clutch out of has had the bendy washers and they never took much effort with a torque gun. Usually if I am...
I have an Arudino and did get it to (roughly) read the RPM signal from the bike. It needed a lot of smoothing which is where my programming skills...
I have used those before after doing rebuilds but my major concern is when the engine is getting run hard. I want to be able to save it before it...
Wow, good finds there! Ultimately I want the sensors to go to a Raspberry Pi that controls everything. But, for now, This looks like it will be...