Separate names with a comma.
I had an issue with mine years ago where it had a dead spot around 10000 RPM, right where you want to cruise. You really had to gun it to get...
Sorry I should have been a little clearer with my explanation. The whole assembly is too short. You pull it as tight as it will go around the...
Just wondering if anyone has replaced their clutch cable on the 3LN1. I bought one off Yamaha and it was 50mm or so shorter than the original one...
If you need to replace the bearings they are very cheap. I picked up a set from Bikebiz and fitted them a few years ago. The ones i pulled out...
I think it's sorted now. I stripped the shifter and sproket cover, gave it all a really good clean and lube and put it back together.
Hi Guys, I went to take my FZR (3LN) for a ride this morning and when I went to shift into second gear for the first time it flatly refused to...
I have just been through the same thing, had a real bad dead spot at about 10000rpm. Found it to be the exup valve not opening early enough. The...
Step That size is correct for the earlier models too according to the Bridgestone fitment guide. There should be a placard on the LHS of the...
Step, When i was looking on the Bridgestone website they sugest to use a tyre called a BT39 for more sport orientated use and it is supposedly a...
G'Day Guys! Just a quick questions to all the Australians on the site. What tyres are you guys running and are you happy with them? I currently...
