Separate names with a comma.
Just checked the rear sprocket & it's 55T so I will do some checking of pick up, terminals etc. Cheers my67wr
The tacho on my 2kr seems to have some sort of intermittent problem - sometimes its a bit jumpy at low rpm's & I think its not showing the correct...
So my 2KR has a spun bearing on one of the conrods & it caused some scoring. Joker has helped me out with a good connecting rod out of a 3LN motor...
Cheers linkin for the info I will have the crank checked & see if i can go down the oversized bearing route but getting hold of a good connecting...
Had some time to pull the motor apart today - found piston 1 had lots of play in the connecting rod bearing so removed it & found this. To me the...
Thanks. The oil has been changed & level is correct, i will check the chain tensioner. I reconnected the exup as it been wired open & is now...
Here's a video at this stage the engine has warmed so the smoke isnt too bad but the knocking sound & bogging down around 10 000 rpm are there....
Finally i found time to work on the carbies again - so i pulled them apart cleaned & checked everything. Plus i repaired one of the rubber/...
I think I may have found part of the problem - I decided to try a air leak test via some air pressure into the carb rubber boot via the sync test...
I bench synced them, soaked the jets etc in carb cleaner then blew them out with an air compressor. The bodies I soaked then gave them a bath in...
Update on my 2kr So the carbs have been all cleaned with a full set of litetek seals, adjusted float levels & its running a little better but...
I'm just about to buy the litetek kit do I need just service kit A or the the B as well ?
Tech info i think would have been better. Choke on doesn't improve cold starting only a squirt of fuel into the carbs. I did give each carb a...
All tips appreciated. Just letting it run out the back & noticed it doesn't want to rev past 10500 rpm then a fair amount of smoke!
No it hasn't been for a decent run only around the block (unlicensed). Yesterday I thought about it but I ran out of time.
No unfortunately i don't have access a leak down tester. The smoke does reduce once its been running for a few minutes. The difficulty starting...
Finally I had time to tinker, thanks to 'joker' some valve shims were sourced & the clearances are all now in spec. So with a warm engine (carbs...
Can't see the pm function Joker - so I pulled out the shims today & these are the shims i need 2x 1.10 2x 1.12 4x 1.22 Do you have those sizes? I...
Joker PM sent re shims
So still waiting to receive the compression tester -aust post is crap 10 days now melb to perth! In the meantime I checked the valve clearances, a...