Separate names with a comma.
The tensioner is all the way out. :( Do you think this one would fit? Like it's for a EX250(Ninja 250r).....
Anyone know where to buy a manual cam chain tensioner for my ZXR250C?!?!
I got the video right now! LINK: [MEDIA]
@cantafforda600 you're a subscriber?! :imtheking: I will get the video tomorrow. The weird is it will not hold idle.. revs don't get stuck (like...
Okay, so my zxr stalled on me a few nights back, & wouldn't start if I had choke on and was giving it some throttle.. There is a huge tapping...
@GreyImport , where can you find that stuff? I am in Hobart TAS so I have absolutely no idea haha. :
I fixed the problem. My carbs weren't sitting in the carb boots properly and I turned the air to fuel mixture screws out a 1/4 of a turn and it...
@kiffsta that should make my bike able to rev the full rev range and not get stuck at about 10,000??
I know I have been annoying LOL But I rebuild the ZXR250c carbs with kits from Motorcycle Spares Warehouse, and my bike idles brilliantly, but in...
I was going to say a late 80's Suzuki GSXR-750/1000 cafe racer convert... but the frame is round tubing not like the square box frame of the...
I figured out the problem, one of the cables that keeps the throttle shut(?) came out of the hole behind the starter block on the bars. I am sorry...
The two lines connect to a smaller t piece which rubs a single line up into the front of the bike? I don't know how to upload photos but will get...
I know about the idle screw, once everything was bolted back down the throttle stuck, played with the idle screw.. nothing NOW a t-piece that...
Thanks guys, the air mix screws didn't have springs, o-rings and the washer.. Oops Now my bike is revving at 6.5k... help me please boys :(
I will look at it again tomorrow. Ran out of day light today I am not sure what the air fuel mixture screws are, if you could upload a photo of...
*rebuilt* the carbs in my zxr250c today, new jets, needles, gaskets, everything. I installed everything, tank is full of 91octane, tried to turn...
G'day guys. On my ZXRc I have these fibreglass fairings, they're basically had it, and I was looking for brand new ones. the ones of ebay don't...
@cal definitely have to do a video on how it sounds when you get it. :)
Hello guys. The muffler I have currently on Bessa, the ZXR bitsa is this huge car cannon full of baffling, as much of a young hoon that I am and...
Will start a thread on this Streetfighter project! will ask for suggestions though :)