Separate names with a comma.
I am a little bit disappointed about the power output. With Injection should be minimum 50-55 HP. I think the exhaust regulations are too strict.
If it's dry you can hang up the bike... 50HP with injection is a little bit low regarding the old models. But for sure because of the exhaust...
Hi all, I still hadn't the time to move forward due to other projects (Cars and other bikes). I am confident to check the compression shortly...
Without knowing exactly, I think, that it depends on the HP/weight ratio, It's similar in Germany and other countries. It could be that it will...
Hello everybody, I only wanted to state, that i didn't came Up to now to check fürther. Hopefully this Week *eek* :) Maybe i forgot to say that...
So, I will do now the standart procedure: -Compression test with warm engine. -Compression test with fill some oil into chamber. -->If...
Thanks for you Infos so far. Is this the compression part from the service manual? makes sense... I searched 3 times:minigun: Would mean 10 bar...
Super, Thanks! Is this for 1 or 4 pistons? It's a confusing describtion. The ebay set Is looking like alloy, even if it's called steel, but never...
Yes, in the descibtions is written steel, see the ebay link:...
Yes, I usually change all sealings which are disassembled. All other would be....hehe. I only have doubts to use steel instead of Alu pistons, due...
OK, thanks. So China Pistons could be worth. Are the OEM Pistons Aluminium oder Steel Pistons? I am asking, cause the Chinese once are advertised...
By the way, does anyone have experience with the China Piston with Ring Sets? Zlthe are China typical unbelievable cheap, but is the quality also...
So, the rebuild was no engine rebuild. The Bike was Stores 10 years. This was 9 years before. Then i fixed every issue that was caused by the...
Hi, here my plugs attached. [ATTACH] Yes fully Open throttle, i know. Usually there have cold ans warm values ( cold für Testing, If engine is not...
OK, i am screwed. Compression test is showing following im bar (cyl 1-4): 5,5 - 6,5 - 6,5 - 6 Was done with cold engine, but without knowing the...
I didn'nt found a suitable connector, so I will wait till I have a new feul filter, need one anyway. So, I came to do test Nr.2. for the first....
Of course, a good method to conclude the float high from the fuel level. Saves a lot of time (and nerves):thumb_ups:
Hi, thanks a lot. But my thought was to measure the the hight of the float body 90° to the housing (not the fuel level it self) This is direct and...
You are right. Only possibility to run lean is with leak air after the carbs.
Good try! Usually the K&N Filters allow more airflow or in other words, have less flow restricition than OEM. But if the Air pressures and...
