Separate names with a comma.
Project back on after a few year break. Have been paying the rego the whole time so figured I should get it finished. Update: Have got the...
Just found this on some site, We carefully check needle jet condition on the vehicles when we create and install carb recalibration kits. If you...
Needles are new, emulsion tubes are original and possibly worn?? There is a definite difference between when choke lever is on and off so I...
Well I know for a fact these particular bikes are alot easier to jet and run better with the airbox but I bought this heap of junk 9 years ago and...
Cheers lads. Now to get to jetting right so the front wheel lifts!
Ok well an update, got my custom electrics tray sorted and mounted the flasher relay, capacitor (flux I wish) and CDI in here among the bird nest...
Thanks mate! Can't way to lay a decent line of smoke or two down some busy roads and let those cafe racer snobs suck up some good old 2 stroke...
No I didn't remove all of those, will remove all that and re-blow out with the compressor again tomorrow and look for an improvement! Thanks for...
Ok got her running on both cylinders! Just had to remove and disassemble the carbs and blow compressed air through every passage way. Works a...
Bit of an update Ok have finally got time and patched and mended the old wiring harness and re-sleeved most of it in split conduit, had a hard...
Bit of an update, Frame and swingarm have been powder coated. Wheels have been sprayed, new rubber fitted. Engine mounted, wheels and drive train...
I would have liked to restore original but so many of the original parts were missing or damaged beyond repair and to find replacements was either...
I would say more of a "brat" style. Generally I be riding 1up but I prefer the convenience of 2up brat styles seats as occasionally I'll use it....
Cut the frame up for the seat hoop and some flat bars to bolt my seat down. Doesnt leave much room for an underseat electrics tray Also ordered...
Hey I bought some aftermarket piston kits 55.5mm or 1.5mm oversize. The rings that came with these kits seem like a bad fit, they would not close...
Hey mate, here http://2fiftycc.com/index.php?threads/79-suzuki-gt250-x7-customised.8510/ Not a great deal to look at yet. Cheers Mitch
All good bro :) Just hoping to match the fork lowers to the frame and wheels. Painting the wheels in a gloss black rattle can VHT brand. Gonna...
Thanks. Have a few dings to the bottom. $400 from the UK :mad:other option was custom at $1200 plus or Higgspeed at $1200.
Oil tank Im thinking of, mounted somewhere in the triangle or I go a flat aluminium inconspicuous type mounted between the frame tubes under the...
One obstacle Im faced with is the gusseting bracing under the seat. I need to cut about where the small red line is to get enough purchase for my...