/ Register

54/53mm Forks, Donor Bikes?

Discussion in 'The Pub' started by KICKERMAN360, Dec 20, 2015.

  1. KICKERMAN360

    KICKERMAN360 Well-Known Member

    Messages:
    389
    Likes Received:
    294
    Trophy Points:
    273
    Joined:
    Oct 26, 2014
    Gender:
    Male
    Location:
    Melbourne/Gold Coast
    My Bike:
    CRF50, CR125, MC21,MC22,CBR600RR
    So Tyga has made some new triple clamps for the NC35 (possibly NC30) and MC21/28 and I dare say they'll probably do the same for some other models.

    So they're supposed to accept CBR600RR forks but they're pretty expensive so I was wondering if anyone had measurements of forks of similar length that might fit (maybe from other naked bikes). My research only yields measurements on the inside fork tube OD.
     
    KICKERMAN360, Dec 20, 2015
    #1
  2. maelstrom

    maelstrom LiteTek Staff Member Premium Member 250cc Vendor Contributing Member

    Messages:
    5,117
    Likes Received:
    3,481
    Trophy Points:
    1,148
    Joined:
    Dec 23, 2012
    Gender:
    Male
    Location:
    Thailand
    Home Page:
    My Bike:
    Yamaha FZR400 3TJ1, Honda MC22
    Yes, I feel your pain. Very little information out there and most of it is not verified. So I thought if I started collecting some information and made a web page, over time people would add to it. Had a few contributions so far. Length is one of the most difficult dimensions to get. The only length I have for Hondas is for the CB-1 (RWU forks) and that came from a forum that helped out.
    http://www.litetek.co/Guide_USD_ForkDatabase.html
     
    maelstrom, Dec 20, 2015
    #2

Share This Page