Separate names with a comma.
Discussion in 'Tech Tips' started by GreyImport, Feb 23, 2013.
all you need to know....
@Andych , it's a bit late now but found this $10 cheaper
Haha...yep, just a little bit too late.
I can't find anywhere that it actually says "JIS" for the Vessel Ball-grip 220W-3 set.
Are we sure the P1 P2 P3 are not just "Phillips" bits?
Philip's are normally listed PH1, PH2 and even just #1 or #2 with the better manufacturer's, like Pozidrives' PZ1 PZ2 etc
Here the 220 series have P1, P2 or +1, +2 etc option's but they only have the individual driver's listed
6-IN-1 Tool, Ball Grip Handle with Interchangeable / Reversible Bit Set (JIS)
Interesting that the one I have bought doesnt show JIS on it at all.. but... I will wait and see when it arrives as it has already been posted.
It does in the link i posted above your post
As long as mine is "actually" a Vessel... the ad for mine in Ebay actually says manufacturer is Bessel lol
No doubt I will find out when it gets here
If I were to buy one JIS screwdriver for carbys would I get the P3?
Or are all sizes necessary for carby overhaul?
I would say get the P2, the medium sized one
This is the one i bought
Get a set of at least 2, 3 if you can get the smallest size as well, you will need them all sometime.There seems to be different size screws, bolts and clamps all over the carbs. A set is cheaper than trying to source screwed up screws.
I am with @my67xr with getting the ball screwdriver... the tips are magnetised and you get a good range of tips as well. Best screwdriver I have ever purchased to be honest.
mukuni sell a screwdriver set for their carbs , not cheap though and only small sizes