Separate names with a comma.
They are normally. But on my 3LN3 the coils were certainly not next to each other facing vertically downward as per that photo! They are on the...
No there aren't any bearings between conrod and piston in a four stroke, in two strokes it's the little end bearing. The bearing between conrod...
Or it could have spun a main bearing. I had a GPZ600R do that to me. I rode it home but it never started again <!-- s:mad: --><img...
It was a genuine yamaha part, cost £47 (UKP), and took 3 weeks to arrive. I kept the old one so I could maybe replace the paper with oiled foam...
Interesting dual compound info...... Ding!! Yeah i was after a tyre that I could run in the rain Someone had fitted a 55T rear sprocket (std...
The Yamaha R1, model 4XV, is I think a 1999 -2001 bike. I think however that all coils on R1's that have carbs are the same. At some point...
I went with the 090 because they are about 10-15% cheaper, and it all adds up in the long run. I use the FZR250 as my everyday bike. I also went...
Have you checked that the choke mechanism is disengaging? You might be moving the lever but if you look at the carb end of the cable - make sure...
[img] I managed to pick up this sorry looking 3TJ FZR400 for £150 with an eye to break it and possibly make a bit of money on it. It looks like...
What do you mean by K1 & K2??? Different models? I noticed my 3LN3 had progressive springs, is it the poundage of each part? Chris
When I rebuilt my Yamaha 350YPVS (RZ to you??) forks it seemed normal practice to use the upper stanchion to pull out the bush in the fork leg...
You see the tail on this bike, this is what I want for mine. <!-- m --><a class="postlink"...
You are in suffolk, england? How much for the side parts for the tailend? The bits that sit under the seats if you look from the side? Chris
Yeah it was great, and that was no optical illusion lol. Going into druids hard on the brakes I was keeping up with nearly all bikes. Mid corner...