Separate names with a comma.
I'm trying to split my engine case and remove the crankshaft, and I think I have one crankcase bolt left behind the magneto housing. I can't get...
I'm looking at the bottom end of my spare 3LN engine, and can't work out where the oil restrictor is. Anyone got a picture of what I need to be...
Unfortunately you appear to be right. Stripped it down today and cylinder 3 piston is loose and the bearing looks melted at some points. Must have...
Was out riding my bike today, having no real issues. Had to get up to 100km/h so I took it up to around 15k RPM and it started to struggle, from...
Had a look at the exup and it seems that the cables were on backwards, so that is all lined up properly now. Running much better at idle and lower...
91 RON, although there is a bit of 98 in there at the moment and it didn't seem to make much difference between the two
From memory I removed the pump and it seemed to run a bit better when I was having a lot of problems a while ago. I can try refit it and see if it...
Finally got my bike running and out on the road after a lot of screwing around. Now I'm just sorting out some little issues. The bike doesn't seem...
Thought I should update this. Bike seems to run better now. It actually moves so thats a start. I think it was due to the plugs needing cleaning,...
Ok I think I will check the tank next. Forgot to mention that I did change the filter, and the fuel pump seemed to be causing issues, so I...
Having the worst luck with this bike. My 3ln fzr250 starts, idles, revs fine in neutral, however it just dies whenever I try to ride it. It seems...