Separate names with a comma.
hey nathan, how did u go with prices on rings etc.
ok i finally got all my parts yesterday and put it all together. was easy to do and no more leaks yay. but bad news is that its blowing more smoke...
sorry guys, what i was meaning was i can buy the internals separately for those prices which totals bout $141 i think or i could have bought a...
i got the seal out so now i know it will an be easy diy job.i rang yamaha and ordered my parts. theese are the prices they gave me: impella- $52...
yer it had lost 500ml of coolant so that why.lol. i just went down and pulled the water pump apart and the seal behind the impeller is stuffed and...
hi all. i went for a big ride yesterday and half way home my bike started getting hot(needle width off red) and wouldn't cool down and just...
hey brad, i'm not real good at this sorta thing but i'll give my 2 cents anyway. now i'm assuming that to get it running u had to disconnect the...
o ok that makes sense. thanks, that would most certainly be a good idea. brake lines might have to wait for a while as i am saving to get new...
dontz125 said: what is the difference between bleeder and non bleeder banjo bolt
ok thanks, it would have been good if they did ay. hey to go to a 2 hose sett up, all i would need is the longer twin hose banjo bolt up top and...
how did u go with the 400 lines okee. did they fit ok. i was thinking about doing the same thing myself.
does any one know if a tzr250 front disk will fit a 89 3LN fizzer
yer i think i will clean out my rear caliper as it was hard to push pistons back in. but the front are ok i thing cause i can push them back in...
Dave said: in cars and trucks i have found this too, that is why i assumed it normal on my bike, but then i came and read the forums.
hi dave, yer i was thinking so too. lol. the little spacer-like things where the disk floats on are loose and can be rattled with my fingers....
hey all, i have a problem again, this time it is brakes. 1. my front left pad scuffs on my rotor so i get off and discover that my right rotor...
thanks dave yer i thought the same as u, so last night i put it back to normal and at idle is races a bit and then back to normal, and when i rev...
yay i finally got it figured out at 11:30 last night lol. because my dad took it apart when i wasn't there like i told him not to, he marked the...
hi dave. i poured a bit of fuel in each one and it just went sorta pop pop but didn't sound like it was gunna start. i pulled the cam cover off...
what are the "emulsion tubes" you speak of and what do they do, how do they wear out.