Separate names with a comma.
do the fzr's normally have a klunky gearbox when changing gears or does it sound like mine is about to go, if so I have spares but am having...
has anyone made their own centre stand for the 250 ??, need to get it up of the ground and milk crates are a bit unstable, if so can you post some...
3 wires coming from harness to thermostat housing (one single - goes to sensor leave as is ) the other two (on mine) brown and blue go to switch...
WOW!! first time bike has started so easy, got it all back together and running no road test yet, have to do a front wheel alignment after i...
thanks m8 just making sure, don't think there are too many bikes that rotate anti-cl-wise, and i decided while i'm at it may as well replace the...
ok grab a beer and cig, timing!!! I am not sure where i am with my timing, i have just put new shims in and put evrything back together took for a...
Well took the 250 for a run today bit of backfiring thru the carbs ( mostly when I open throttle ) but then again had no filter box on, and...
johnnyangel Redcliffe Qld
<!-- m --><a class="postlink" href="http://attachments.fzr250.com/FZR250/3HX1_1988_Part_numbers.pdf">http://attachments.fzr250.com/FZR250/3H ......
thanx dave but i'll wait til 2morrow see how she runs then, feel confident tho
well shims in, all 155s,motor running, can't take it for run yet still raining but will take cover of tomorrow and check the cam chains for proper...
now thats a familiar sight, I've got to work outside as well make sure you put a tarp down under bike to catch bolts and washers, Air Filter-...
maths is not my strongest, thats why it's up here so someone can see where i'm going wrong, but by the sound of it i should use 155 shims for 1,2...
http://www.bikepics.com/pictures/2389988/
OK heres what i've so far, put 150 shims under buckets of No 1 cyl and after a lot of mucking around putting chain and cam back in measured...
hi dave, feeler guages both metric and imp sizes put both on not sure who reads what, using Stanley feeler guages, am getting back into it today...
ok while waiting for "some-one any-one" I did some measurements I'll go from cycl 1 - 4_ valve by valve and the shim size 1. in <.0015 - .038 shim...
are valve clearances for fzr400 the same as 1989 fzr250 2kr 1hx, I only have manual for fzr400 and mine is a 250 I am at the stage of measuring...
thanx buddy was going to have a go today but pissing down rain at the moment if it doesn't ease over the weekend probably next, was even going to...